Insteon Motion Sensor (2842-222, 2420M) Manuel d'utilisateur

INSTEON Motion Sensor 2842-222Quick Start Guide

®INSTEON Motion SensorSet Button(Cover Removed)Status LED9V Battery (Included)Settings JumpersWall Mount Retention Slot

Jumper SettingsTo congure settings like Night-Only mode and Light Sensitivity via the INSTEON Hub, ensure jumper ve is installed over both pins.

Sensor PlacementAx the mount to a surface and slide the mount into the retention slot on the rear of the sensor. Avoid areas of rapid heat change.Mot

1Follow the on-screen instructions to add your Motion Sensor to the INSTEON Hub.Linking to the Hub+If not using the Hub, refer to the instructions tha

2Remove the back cover and when prompted, press and hold the set button until the status LED begins blinking.Tap the set button. The status LED will d

INSTEONScheduleTime of DaySunriseSunsetCongure AlertsTrigger a SceneTo receive email and text message alerts when motion is detected, switch on alert

RAW-1297 Rev 03.13.14Protected under U.S. and foreign patents (see www.insteon.com/patents)©2014 INSTEONMANUALLearn MoreFor the complete Owner’s Manu